Epoxy Primer

MOTIP Epoxy Primer is an all-purpose 1K primer that provides excellent adhesion and corrosion prevention on sheet steel, zinc-coated steel, aluminium and anodised aluminium. It can be used for spot repair and refinishing parts. It is fast drying with good flow and can be applied wet-on-wet. It also offers good insulation against humidity.

  • grey
  • mat
  • 400 ML

Characteristics

  • 1K Epoxy primer is an all purpose 1K primer and provides excellent adhesion and corrosion prevention on sheet steel, zinc-coated steel, aluminium and anodised aluminium.
  • Overcoatable with solvent-based and water-based topcoats
  • Fast drying
  • Good protection against moisture.
  • Wet-on-wet application possible

Technical Data Sheet

Safety data sheet(s)

Usage instructions

Before use, carefully read the directions on the packaging and act accordingly.

Pre Treatment: The surface should be clean, dry and free of grease (with MOTIP Silicone Remover). Remove loose old lacquer and rust and sand the surface.

Treatment: The surface should be clean, dry and free of grease. The aerosol should have room temperature. Best processing temperature 10 to 30°C.

Before use, shake the aerosol for 2 minutes and spray a sample. Distance to the surface to be treated approximately 15 to 20 centimetre.

Apply the primer in several thin layers. Before applying the next layer, again shake the aerosol.

After use, clean the valve (turn aerosol upside down and press the nozzle for approximately 5 seconds).

The drying time depends on the ambient temperature, the humidity of the air and the thickness of the lacquer applied.

Il tempo di essiccazione dipende dalla temperatura ambientale, dall'umidità atmosferica e dallo spessore dello strato applicato.

Colours

grey

400 ML
Mat
Art. nr. 04131
EAN 8711347266760

* colours may differ from the preview above.

Choose your language

How to find a car paint colour code

Need to know the colour of your car? It’s actually located on your car. Even if two paint colours look the same, car manufacturers make loads of different exterior paint colours and they can all vary from year to year, so you need to make sure the code is right to get an exact paint match. Find out below where you can find your car’s colour.

Your car brand

Car example

Most common places

The image above shows the most common places where you can find your colour code. If you select your car brand you will see a specific image containing the locations for your vehicle.

Variation

Car manufacturers have different production series where they might use paints from different paint manufacturers. Therefore, it can occur there are slight changes in colour shade under the same car colour code. To supply everyone, MOTIP makes these variations available. Is there a check mark visible in this column? This means you have a colour code with variations. The differences are small. However, they may be noticeable. We simply cannot say precisely which article best matches the colour of your car. In this case, we’d recommend you check the colour chart at a shop. If you do want to try, always spray a small sample to check if the colour matches the colour of the car.